it\'s a "soft touch" T18 RED knob that works great with our Panel Mount 10K and Panel Mount 100K potentiometers. The knob is designed to set directly on the potentiometer\'s ridges so it\'s an easy amp; secure fit. It has a nice feel, with a rubbery grip, tweaking it is quite fulfilling.
This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive female barrel jack. If you have a power supply with a barrel jack and want to plug it into a breadboard, this might be the simple solution.
This is a cute half size breadboard which has 400 tie-points, is great for small projects. it\'s 2.2" x 3.4" (5.5cm x 8.2cm) with a standard double-strip (300pts) in the middle and two power rails (100pts) on both sides. You can pull the power rails off easily to make the breadboard as thin as 1.4" (3.5cm) and stick it onto your Raspberry Pi. You...
This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, center-positive male barrel jack. If you need to connect bare wires to a barrel jack on an Arduino or a development board, this might be the simple solution.
Screw Terminals with 3.5mm pitch 2 pins. Comes in 2 or 3 positions and have
the really cool feature of slide-locking together to form any size you need (4,
5, up to 20 without problems). Rated up to 125V @ 6A. Terminal can accept 30 to
20AWG wire. 3.5mm/138mil pin pitch will not fit\'standard 0.1" perf boards but
this is the most common pitch...