Sommer Öffnungszeiten ab 22.07.2024 ist Montag - Freitag von 10:00 - 15:00, Samstag von 10:00 - 12:00 und Sonntag geschlossen ×

ACS712 Low Current Sensor Breakout

This current sensor gives precise current measurement for both AC and DC signals. These are good sensors for metering and measuring overall power consumption of systems. The ACS712 current sensor measures up to 5A of DC or AC current. We added an opamp gain stage for more sensitive current measurements. By adjusting the gain (from 4.27 to 47) you can measure very small currents.

The ACS712 Low Current Sensor Breakout outputs an analog voltage that varies linearly with sensed current. To calibrate, first set the output offset to the desired level (with zero current on the sense lines, read output with a DVM). Then with a known current input (a 100mA limited supply works well for this), set the output deflection with the gain pot. Sensitivity is then calculated as (Vref - Vdeflect)/(current input).

The bandwidth on the ASC712 Low Current Sensor Breakout has been set to 34Hz to reduce noise when using at high gains. The full 80KHz bandwidth that the sensor is capable of can be recovered by removing C1. See schematic for more details.

10,35 €
inkl. 20% USt. , zzgl. Versand
Nicht auf Lager

Beschreibung

Beschreibung

This current sensor gives precise current measurement for both AC and DC signals. These are good sensors for metering and measuring overall power consumption of systems. The ACS712 current sensor measures up to 5A of DC or AC current. We added an opamp gain stage for more sensitive current measurements. By adjusting the gain (from 4.27 to 47) you can measure very small currents.

The ACS712 Low Current Sensor Breakout outputs an analog voltage that varies linearly with sensed current. To calibrate, first set the output offset to the desired level (with zero current on the sense lines, read output with a DVM). Then with a known current input (a 100mA limited supply works well for this), set the output deflection with the gain pot. Sensitivity is then calculated as (Vref - Vdeflect)/(current input).

The bandwidth on the ASC712 Low Current Sensor Breakout has been set to 34Hz to reduce noise when using at high gains. The full 80KHz bandwidth that the sensor is capable of can be recovered by removing C1. See schematic for more details.

Documents

Bewertungen

Geben Sie die erste Bewertung für diesen Artikel ab und helfen Sie Anderen bei der Kaufentscheidung:

Kunden kauften dazu folgende Artikel:
Jumper Wire Female to Male 10Pin - 20cm
Top bewertet
> 50 lagernd SKU: SER00063
HC-SR04 Ultrasonic Sensor
HC-SR04 Ultrasonic Sensor
Top bewertet
45 auf Lager SKU: SER00458
Male DC Power adapter - 2.1mm jack to screw terminal block
Male DC Power adapter - 2.1mm jack to screw terminal block
> 50 lagernd SKU: SER00018
9V Batterie Clip Snap
Ausverkauft
Nicht auf Lager SKU: SER00016
Barrel Jack Power Switch - M-F (7.6cm)
Barrel Jack Power Switch - M-F (7.6cm)
Ausverkauft
Nicht auf Lager SKU: SPC11705
Break Away Male Header - Straight 2mm
Ausverkauft
Nicht auf Lager SKU: SER00184
Loading ...
kein Bild
Artikelnummer:
ab *
/
In den Warenkorb
zum Angebot