Der neue Raspberry Pi 5 auf Lager ×

Sunny Buddy - MPPT Solar Charger

This is the Sunny Buddy, a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Sunny Buddy and your battery into the other and you are good to start charging!

29,07 €
inkl. 20% USt. , zzgl. Versand
Nicht auf Lager
Beschreibung

This is the Sunny Buddy, a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Sunny Buddy and your battery into the other and you are good to start charging!

The output of the Sunny Buddy is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Sunny Buddy comes set to a maximum charge current of 450mA with a maximum recommended input of 20V (minimum 6V). I rsquo;s recommended that batteries not be charged at greater than their capacity rating; thus, the smallest battery that should be charged with the Sunny Buddy is 450mAh.

Each Sunny Buddy comes equipped with a LT3652 power tracking 2A battery charging circuit and pre-installed barrel jack and 2-pin JST connectors with unpopulated areas to install your own personal 3.5mm screw terminals for added input/output options.

Documents

Bewertungen

Geben Sie die erste Bewertung für diesen Artikel ab und helfen Sie Anderen bei der Kaufentscheidung:

Kunden kauften dazu folgende Artikel:
Male DC Power adapter - 2.1mm jack to screw terminal block
Male DC Power adapter - 2.1mm jack to screw terminal block
> 50 lagernd SKU: SER00018
Arduino Stapelbarer Header Bausatz - R3
Arduino Stapelbarer Header Bausatz - R3
40 Auf Lager SKU: SPP11417
Raspberry Pi 3 Model B+ Plus 1,4 Ghz 1GB RAM
Raspberry Pi 3 Model B+ Plus 1,4 Ghz 1GB RAM
Ausverkauft
Nicht auf Lager SKU: SER00807
Conductive Thread Bobbin - 9 Meter (Stainless Steel)
Conductive Thread Bobbin - 9 Meter (Stainless Steel)
Ausverkauft
Nicht auf Lager SKU: SPD10867
LiPo Fuel Gauge
LiPo Fuel Gauge
Ausverkauft
LiPo Fuel Gauge
13,50 € *
Nicht auf Lager SKU: SPT10617
NCP1402 - 5V Step-Up Breakout
NCP1402 - 5V Step-Up Breakout
Ausverkauft
Nicht auf Lager SKU: SPP10968
Loading ...
kein Bild
Artikelnummer:
ab *
/