Sommer Öffnungszeiten ab 22.07.2024 ist Montag - Freitag von 10:00 - 15:00, Samstag von 10:00 - 12:00 und Sonntag geschlossen ×

NFC RFID 25mm Sticker - MIFARE 1K (13.56 MHz)

This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

1,00 €
inkl. 20% USt. , zzgl. Versand
Nicht auf Lager

Beschreibung

Beschreibung

This is a blank MiFare Classic 1K sticker - often used for laundry or identification but also found in other systems where a small proximity card is desired. This one is clear! The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN522 NFC/RFID breakout board and NFC/RFID Shield for Raspberry Pi!

These chips can be written to amp; store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writ's. You can use our PN532 NFC/RFID breakout board or NFC/RFID Shield for Raspberry Pithe ID number cannot be changed.

These use the S50 chipset, which used to be the 'classic' NFC chipset. In ~2014, the NFC forum decided not to support this chipset anymore, so newer phones do not support the MiFare classic. This only matters if you're trying to use this tag with a phone/tablet.

S50 Chip Specification:

  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
  • Built in encryption engine with 48-bit key
  • 4 Byte unique identifier burned into the chip
  • 13.56 MHz frequency

Tag specification:

  • 25.4mm diameter x 1mm / 1" diameter x 0.03"
  • 0.9 grams / 0.03 oz
  • Works about 2" away from reader

Downloads: NXP S50 datasheet

Bewertungen

Geben Sie die erste Bewertung für diesen Artikel ab und helfen Sie Anderen bei der Kaufentscheidung:

Kunden kauften dazu folgende Artikel:
NFC RFID Plastikkarte - NTAG215 504byte (13.56Mhz)
Nicht auf Lager SKU: SER01131
Jumper Wire Female to Female 10Pin - 20cm
> 50 lagernd SKU: SER00110
Break Away 2x20 Pin Strip Dual Male Header
20 stück auf Lager SKU: SER00752
1 Pin Dupont Cable Housing
> 50 lagernd SKU: SER00079
Raspberry Pi Pico W
Raspberry Pi Pico W
> 50 lagernd SKU: RPI00068-001
Jumper Wire Female to Male 10Pin - 20cm
Top bewertet
> 50 lagernd SKU: SER00063
Mini Servo SG90
> 50 lagernd SKU: SER00137
2x3 Pin Dupont Cable Housing
> 50 lagernd SKU: SER00117
Raspberry Pi 5 Active Cooler
> 50 lagernd SKU: RPI00109
Female DC Power adapter - 2.1mm jack to screw terminal block
Female DC Power adapter - 2.1mm jack to screw terminal block
> 50 lagernd SKU: SER00017
NFC RFID Sticker - NTAG213 144byte (13.56Mhz) 25mm
Ausverkauft
Nicht auf Lager SKU: SER01118
NFC RFID Plastikkarte - MIFARE 1K (13.56 MHz)
Ausverkauft
Nicht auf Lager SKU: SER00192
Kühlkörper für Raspberry Pi 4 CPU
Kühlkörper für Raspberry Pi 4 CPU
Ausverkauft
Nicht auf Lager SKU: SER00854
Momentary Push Button Switch - 12x12x8mm
Ausverkauft
Nicht auf Lager SKU: SER00093
Loading ...
kein Bild
Artikelnummer:
ab *
/
In den Warenkorb
zum Angebot