Simple but effective - this sewable breakout board has a CR2032 coin cell battery holder soldered on, an on/off switch and 0.1" pitch breakout pins for easy connecting. Great for powering very low-current projects, or adding a battery backup circuit to a real-time-clock or similar. There's two ground pins, one 'switched' power pin, and one pin that is always on.
Comes with one fully assembled and tested coin cell battery holder and a small stick of 0.1" header so you can solder it on and plug into a breadboard. Coin cell battery is not included.
- 23.5mm x 28mm x 1.6mm / 0.9" x 1.1" x 0.06"
- Mounting hole distance: 18mm x 22mm / 0.7" x 0.9"
- Weight: 3g