Introducing the WiPy 2.0. The tiny Micro Python enabled WiFi amp; Bluetooth IoT development platform. With a 1KM WiFi range, state of the art Espressif ESP32 chipset and dual processor, the WiPy is all about taking the Internet of Things to the next level.
Create and connect your things everywhere. Fast.
Powerful CPU, BLE and state of the art WiFi radio
1KM Wi Range
MicroPython enabled, the Linux of IoT for fast deployment
Fits in a standard breadboard (with headers)
Ultra-low power usage: a fraction compared to other connected micro controllers
Hardware floating point acceleration
Espressif ESP32 chipset
Dual processor + WiFi radio System on Chip.
Network processor handles the WiFi connectivity and the IPv6 stack.
Main processor is entirely free to run the user application.
An extra ULP-coprocessor that can monitor GPIOs, the ADC channels and control most of the internal peripherals during deep-sleep mode while only consuming 25uA.
The board ships with male headers mounted as seen on the pictures.
These DC powered heating pads are perfect for near-body heating applications. They get warm to the touch but not too hot. Simply apply 5VDC to the wire leads and within minutes, the pad will begin to warm up.
Resistors are a good thing, in fact, they\'re actually crucial in a lot of circuit designs. The only problem seems to be that resistors disappear into thin air. The only way to be sure that you\'re gonna have the resistor you need when you need it is to stock up, and keep them organized. We have just the thing!
You\'ve got the wrong USB cable. It doesn\'t matter which one you have, it\'s the wrong one. But what if you could have the right one? What if you could have the right one every time? Enter: The Cerberus.
The Digispark is an Attiny85 based microcontroller development board similar to the Arduino line, only cheaper, smaller, and a bit less powerful. With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE the Digispark is a great way to jump into electronics, or perfect for when an Arduino is too big or too...
The non-contact infrared thermometer (MLX90614ESF) for use with Arduino, or any microcontroller that can communicate with it through it\'s I2C interface.This sensor comes with a breakout board with all of the components needed for operation and two types of pins. They are unsoldered.
This is a cute half size breadboard which has 400 tie-points, is great for small projects. it\'s 2.2" x 3.4" (5.5cm x 8.2cm) with a standard double-strip (300pts) in the middle and two power rails (100pts) on both sides. You can pull the power rails off easily to make the breadboard as thin as 1.4" (3.5cm) and stick it onto your Raspberry Pi. You...
A central mounting hole on the front side to allow for three point mounting. This is much easier for bed leveling in comparison to 4 point mounting. First level the side with two holes and fix in place, then level the side with one hole. A glass plate is highly recommended to provide a truly flat surface and rigidityThe pads to solder onto have been...
4 auf Lager
Du erhälst eine Email benachrichtigung wenn das Artikel wieder auf Lager ist