To facilitate the use of Raspberry Pi and screen module to work together, we specifically developed a simple adapter board and customized a batch of 26-pin (2X13) cable . Simply insert the screen module into the adapter board, then connect the board and Raspberry Pi plate with cable, thus the hardware connection is done, saving the trouble of corresponding connection of each pin.
This adapter kit is compatible with ITDB02-2.2, ITDB02-2.4E and ITDB02-2.8. NOT compatible with ITDB02-3.2S , ITDB02-3.2WD.
We use barrel jacks a lot around here and sometimes we need to pop a switch into the mix. That usually means hacking up a perfectly good barrel jack extension cable, but the whole point of using the barrel jacks was so that we wouldn\'t have to hack things apart... Well, we found a solution: The Barrel Jack Power Switch.
The Fio v3 is a new spin on the Arduino Fio hardware powered by the ATmega32U4.Not only is it\'small and LiPo-ready, it\'s a very capable XBee-ready development board.
The JST-connector and 3.3v system voltage make this a great development tool for portable devices, simply plug in a Li-Poly battery and you\'re ready to go. Wireless sensor networks and...
Screw Terminals with 3.5mm pitch 2 pins. Comes in 2 or 3 positions and have
the really cool feature of slide-locking together to form any size you need (4,
5, up to 20 without problems). Rated up to 125V @ 6A. Terminal can accept 30 to
20AWG wire. 3.5mm/138mil pin pitch will not fit\'standard 0.1" perf boards but
this is the most common pitch...
Single row of 40-holes, female header. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use them extensively in the Olimex development boards. They mate very well with break away male headers.
This is a row of 40 break away headers spaced 0.1" apart with long pins on both sides. This header is especially useful when you need to connect a PCB to a solderless breadboard. Each header can be broken apart to your preference to fit custom PCBs or general custom headers.
This is a simple board that no one really needs but it\'sure comes in handy. If you\'ve ever tried to hook up an FTDI to something only to realize you need to swap the TX and RX, maybe you could use this board. Sure, you can grab some jumper wires and make your own, but this little crossover board makes it much easier.