Have you ever needed a cheap way to activate something from across the room? Infrared remotes are still the cheapest way to wirelessly control a device. We chose this remote because it's small, very simple, and low-cost. For the majority of the projects we build, we don't need 34 buttons, we need one or two. This is the smallest IR remote control we could find.
The remote does control volume, power, and mute on most of the IR equipment in our office. Unfortunately we can't guarantee that it will work with your 1995 Pioneer 5-disc CD player though. Rather, we are carrying this remote to work with many of the more common IR receiver ICs.
Check the pictures, we tore one apart so you can see what's on the inside.
Note: The unit comes with a CR2025 coin cell battery.
Note: it's come to our attention that on some (if not most) models of TV, the channel buttons on this remote will act opposite to the way they're marked. Channel up changes the channel down and vice versa. If you're using this remote with your own embedded application, this shouldn't affect anything.
Use this simple IR receiver for infrared remote control of your next project. With low power consumption and an easy to use package, it mates well with embedded electronics and can be used with common IR remotes.
This is a small prototyping shield for the Arduino Pro Mini. If your project requires just a little bit more space for your external circuitry, this might be a perfect addition. 38 unconnected PTHs are provided for your prototyping needs.
Round and round and round they go! 16 ultra bright smart LED NeoPixels are arranged in a circle with 1.75" (44.5mm) outer diameter. The rings are \'chainable\' - connect the output pin of one to the input pin of another. Use only one microcontroller pin to control as many as you can chain together! Each LED is addressable as the driver chip is...
Trinket may be small, but do not be fooled by its size! it\'s a tiny microcontroller board, built around the Atmel ATtiny85, a little chip with a lot of power. We wanted to design a microcontroller board that was small enough to fit into any project, and low cost enough to use without hesitation. Perfect for when you don\'t want to give up your expensive...
Single row of 30-holes, female header with swiss round machined pins. These units have very high quality round pins to accept and retain machine pin headers much better. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use them extensively in the Olimex development boards. They mate very well with break away headers.
Slim clicky momentary switches are standard input "buttons" on electronic projects. These are half the width of classic 6mm tactile switches so they line up better on a breadboard, just plug them into every-other row.
Single row of 40-holes, female header. Can be cut to size with a pair of wire-cutters. Standard .1" spacing. We use them extensively in the Olimex development boards. They mate very well with break away male headers.
81 auf Lager
Du erhälst eine Email benachrichtigung wenn das Artikel wieder auf Lager ist