This is a Temperature Breakout with DS18B20 from Maxim IC. Reports degrees C with 9 to 12-bit precision, -55C to 125C (+/-0.5C). Each sensor has a unique 64-Bit'serial number etched into it - allows for a huge number of sensors to be used on one data bus. This is a wonderful part that is the corner stone of many data-logging and temperature control projects.
Unique 1-Wire¨ interface requires only one port pin for communication
Each device has a unique 64-bit'serial code stored in an onboard ROM
Multidrop capability simplifies distributed temperature sensing applications
Requires no external components
Can be powered from data line. Power supply range is 3.0V to 5.5V
Measures temperatures from 55¡C to +125¡C (67¡F to +257¡F)
±0.5¡C accuracy from 10¡C to +85¡C
Thermometer resolution is user-selectable from 9 to 12 bits
Converts temperature to 12-bit digital word in 750ms (max.)
User-definable nonvolatile (NV) alarm settings
Alarm search command identifies and addresses devices whose temperature is outside of programmed limits (temperature alarm condition)
Applications include thermostatic controls, industrial systems, consumer products, thermometers, or any thermally sensitive system
The Genuino Mega 2560 is a microcontroller board based on the ATmega2560. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the...
The LM335Z is a very easy-to-use analog temperature sensor. The LM335Z works like a Zener diode with a breakdown voltage proportional to absolute temperature at 10mV/¡K. Hook up a resistor from 5V and GND, and the LM335Z will output an analog voltage of 2.98V (298 Kelvin is 25C or room temperature). The output of the sensor is linear, and when...
This 4" / 100mm long flexible uFL 2.4GHz antenna has approx 4DBi gain and a 50O impedance so it will work fantastically with just about any 2.4-2.5GHz wireless receiver/transmitter such as the CC3300 Wifi Breakout !
This Original Raspberry Pi Camera Holder in Black are compatible with the Raspberry Pi A and Raspberry Pi B and can mount with regular Raspberry Pi Camera and with the Rapsberry Pi Camera NoIR . We have them in three different colors available: Black, White, Transparent.
This I2C digital temperature sensor is one of the more accurate/precise we\'ve ever seen, with a typical accuracy of ±0.25¡C over the sensor\'s -40¡C to +125¡C range and precision of +0.0625¡C. They work great with any microcontroller using standard i2c. There are 3 address pins so you can connect up to 8 to a single I2C bus without address collisions....
The Raspberry Pi 2 Blue Acrylic Case is an easy DIY Case to protect your Raspberry Pi B+ and Raspberry Pi 2. The Top of the case can be opened and the Raspberry Pi 2 can be fixed to the bottom of the Board. The Dimensions are 9.3 x 6.5 x 3.2cm.