The Arduino Prototyping Shield makes it easy for you to design custom circuits. You can solder parts to the prototyping area to create your project, or use it with a small solderless breadboard (not included) to quickly test circuit ideas without having to solder. it's got extra connections for all of the Arduino I/O pins, and it's got space to mount through-hole and surface mount integrated circuits. it's a convenient way to make your custom circuit and Arduino into a single module.
The Proto Shield bring the power from the Arduino standard 5V and GND pins to the two power bus rows placed between the Through Hole package footprint, which can be used for powering the DIP sockets, or for power and ground rows.
The ICSP connector available on the shield hove his connections made directly to the SPI pins.
1: (the one with the smal pointer sign) MISO connected to D12
3: SCK connected to D13
4: MOSI connected to D11
5: SS connected to D10
For more information about the SPI communication see the SPI library.
The maximum length and width of the Proto Shield PCB are 2.7 and 2.1 inches respectively. Three screw holes allow the shield to be attached to a surface or case. Note that the distance between digital pins 7 and 8 is 160 mil (0.16"), not an even multiple of the 100 mil spacing of the other pins.
If you are sourcing a ultrasonic ranging module , the HC-SR04 is good choose . Its stable performance and high ranging accuracy make it a popular module in electronic market .Compared to the Shap IR ranging module , HC-SR04 is more inexpensive than it . But it has the same ranging accuracy and longer ranging distance.
This 47 x 35mm (1.84 x 1.37") breadboard has 17 rows of tie points, enough for up to two 14 or 16 pin DIP integrated circuits (ICs). The board features an adhesive backing and is Transparent color. Add some color to your next project!
Now that you\'ve finally got your hands on a Raspberry Pi¨ , you\'re probably itching to make some fun embedded computer projects with it. What you need is an add on prototyping Pi Plate from Adafruit, which can snap onto the Pi PCB (and is removable later if you wish) and gives you all sorts of prototyping goodness to make building on top of...
Add some jazz amp; pizazz to your project with a color touchscreen LCD. This TFT display is big (2.8" diagonal) bright (4 white-LED backlight) and colorful! 240x320 pixels with individual RGB pixel control, this has way more resolution than a black and white 128x64 display. As a bonus, this display has a resistive touchscreen attached to it...
These 10 segment bar graph LEDs have many uses. With a compact footprint, simple hookup, they are easy for prototyping or finished products. Essentially, they are 10 individual RED LEDs housed together, each with an individual anode and cathode connection.
This is a cute half size breadboard which has 400 tie-points, is great for small projects. it\'s 2.2" x 3.4" (5.5cm x 8.2cm) with a standard double-strip (300pts) in the middle and two power rails (100pts) on both sides. You can pull the power rails off easily to make the breadboard as thin as 1.4" (3.5cm) and stick it onto your Raspberry Pi. You...