A button is a button, and an LED is a LED, but this LED illuminated button is a lovely combination of both! it's a medium sized button, large enough to press easily but not too big that it gets in the way of your project panel. It has a built in LED that can be controlled separately from the switch action - either to indicate or just to look good.
The body is a black plastic with the LED built inside. There are two contacts for the button and two contacts for the LED, one marked + and one -. The forward voltage of the LED is about 2.2V so connect a 220 to 1000 ohm resistor in series just as you would with any other LED to your 3V or higher power supply.
This particular button has a red body and LED and is momentary, normally open. The two switch contacts are not connected normally. When you push the button they will temporarily connect until the button is released. The LED is separated from the button, so you can make it light up when pressed, light up when not pressed, always lit, etc.
Max Dimensions: 18.06mm / 0.7" x 18mm / 0.7" x 29.4mm / 1.15"
Shaft Dimensions: 14.89mm / 0.58" x 15.56mm / 0.6" x 18.7mm / 0.73"
If you are sourcing a ultrasonic ranging module , the HC-SR04 is good choose . Its stable performance and high ranging accuracy make it a popular module in electronic market .Compared to the Shap IR ranging module , HC-SR04 is more inexpensive than it . But it has the same ranging accuracy and longer ranging distance.
it\'s a "soft touch" T18 RED knob that works great with our Panel Mount 10K and Panel Mount 100K potentiometers. The knob is designed to set directly on the potentiometer\'s ridges so it\'s an easy amp; secure fit. It has a nice feel, with a rubbery grip, tweaking it is quite fulfilling.
This is the P2N2222A, an NPN silicon BJT (Bipolar Junction Transistor). This little transistor can help in your project by being used to help drive large loads or amplifying or switching applications. The P2N2222A is specifically rated at 40V and 200mA max
This is a cute half size breadboard which has 400 tie-points, is great for small projects. it\'s 2.2" x 3.4" (5.5cm x 8.2cm) with a standard double-strip (300pts) in the middle and two power rails (100pts) on both sides. You can pull the power rails off easily to make the breadboard as thin as 1.4" (3.5cm) and stick it onto your Raspberry Pi. You...
If you\'ve ever wondered how to control high current devices from a low-power microcontroller, a MOSFET is what you need. The NDP6020P is a very common MOSFET with very low on-resistance and a control voltage (aka gate voltage) that is compatible with most 5V and 3.3v microcontroller or mechanical switches. This allows you to control high-power devices...
This 47 x 35mm (1.84 x 1.37") breadboard has 17 rows of tie points, enough for up to two 14 or 16 pin DIP integrated circuits (ICs). The board features an adhesive backing and is Transparent color. Add some color to your next project!
The Rotary Potentiometer - 100k Ohm is an adjustable potentiometer can open up many interesting user interfaces.
Turn the pot and the resistance changes. Connect VCC to an outer pin, GND to the
other, and the center pin will have a voltage that varies from 0 to VCC
depending on the rotation of the pot. Hook the center pin to an ADC on a...
This is a standard 12mm square momentary button. What we really like is the large button head and good tactile feel (it "clicks" really well). This button is great for user input on a PCB or a good, big reset button on a breadboard. Breadboard friendly!